Most Florida homes, including the majority around Coleman, are built slab-on-grade. Supply lines and drains run through or beneath that concrete, out of sight for decades. When one of them springs a leak, the water has nowhere to go but into the soil, the slab and eventually your flooring. K&K Plumbing provides slab leak detection in Coleman FL with tools that find the problem precisely so the repair stays small.
Clues When You Do Not Have a Water Bill
City customers often learn about slab leaks from a shocking utility bill. Many Coleman households draw from private wells, so the warning signs look different:
- The well pump cycles on with every faucet closed and no irrigation running
- The pressure gauge on the tank slowly falls overnight
- Warm spots on tile or concrete, which usually mean a hot water line is leaking
- Damp carpet, lifted laminate or musty odors near interior walls
- New cracks in baseboards, tile grout or drywall
- The sound of running water inside a wall when the house is quiet
On a well, extra pump run time can also show up on your electric bill. If you suspect a leak, our guide to the signs you need a slab leak inspection is a good checklist.
Why Slab Pipes Fail Here
Sandy Sumter County soil shifts with heavy summer rains and dry spells, which stresses pipes locked in concrete. Hard well water and older copper or galvanized lines corrode from the inside, and a pipe that rubs against rebar or gravel for years can wear through. High pressure from a well system with a misadjusted pressure switch adds to the strain.
How We Find the Leak
Our process is methodical rather than destructive:
- Isolate the system. We separate hot from cold and test each with pressure gauges to confirm which line is losing water.
- Trace the piping. Electronic locating equipment maps where lines run beneath the slab.
- Listen and scan. Acoustic listening devices pick up the sound of escaping water through concrete, and thermal imaging spots the heat signature of a hot line leak.
- Mark the spot. You get a clear explanation of where the leak is and what it will take to fix.
Three Ways to Repair It
Spot repair through the slab. We open a small section of floor directly over the leak, repair the pipe and restore the concrete. This works well for a single, isolated failure.
Rerouting. The damaged line is abandoned and a new one is run through walls or the attic. This avoids breaking more concrete and is often the better long-term choice in older homes.
Repiping. If testing shows several weak spots, replacing the supply system may be wiser. Our repiping service in Coleman covers that option.
We provide upfront pricing for each approach that fits your situation and help you weigh cost against how long the fix will last.
What to Do Until We Get There
If the leak seems to be on the hot side, turn off the water heater and close its cold inlet valve, which often stops the flow to the leaking line while leaving cold water available. If you cannot tell, close the main shut-off or switch off the well pump breaker. Pull back rugs from damp spots and run a fan to slow mold growth.
Licensed, Local and Careful
K&K Plumbing has served Sumter County since 2009 under Florida license CFC1431523. Read more about our slab leak detection and repair service or see everything we do on the Coleman service area page.
Hearing the pump run when everything is shut off? Call or text 352-810-9472 and we will schedule leak detection at your Coleman home before the water does more damage.